Elevated Work Platform and Scissor Lift Training in Vaughan
CLASSROOM TRAINING CONTENT
- Current applicable legislation
- Vehicle stability
- Causes of accidents and injury
- Stabilizer systems
- Operator responsibility
- On-slab versus rough terrain
- Pedestrian awareness
- Powerline clearances
- Fall protection (equipment specific)
- Capacity plates
- Control systems
- Pre-shift inspection and reporting procedures
- Work site inspection
- Hazard awareness
PRACTICAL TESTING (FOR EXISTING OPERATORS)
Practical operator testing is held on-site at your facility and follows the classroom training. The operator is tested individually and put through a series of operating tasks and manoeuvres to assess competency and safety awareness on the equipment. Pre-shift inspection and reporting procedures are also covered. Average testing time is approximately 30 minutes per operator.
PRACTICAL TRAINING (FOR NEW OPERATORS)
Participants with limited or no practical operating experience will require practical training prior to practical testing. The duration of practical training varies based on equipment type and aptitude of the operator. Practical training is an additional charge to this program and should be pre-scheduled.
DURATION & LOCATION
- 4 hour classroom training session on site at your location;
- 30 minute practical operating test held on-site at your location. (additional time will be required for testing on more than 2 pieces of equipment)
- Classroom theory training
- Practical operating test on up to 2 pieces of equipment (providing 2nd test takes place at the same time & location)
- Record of training report
- Written examinations
- Signed safety rules from each participant
- Individual wallet certificates (for participants with 80% passing score on both written and practical tests)